2. Warm up the engine to operating temperature and stop it.
3. After a few minutes, slowly pull the dipstick out and wipe the oil clean.
4. Reinsert the dipstick as far as it will go.
5. Pull out the dipstick again and check the oil level if it is between "F" and "L" marks.
6. If the engine oil level is too low, add the engine oil. For recommended engine oil.
Engine Oil Change
1. Park the vehicle on a level surface.
2. Warm up the engine to operating temperature and stop it.
3. Remove the oil filter cap.
4. Place a container under the drain plug for draning engine oil.
5. Remove the drain plug and gasket with a wrench, and allow the oil to drain completely.
Wear protective glasses, if necessary.
6. Loosen the oil filter with and oil filter wrench and remove it by hand.
7. Apply a little engine oil on the rubber gasket of the new oil filter.
8. Screw the new filter into place and lighten it by hand until the gasket contacts the east.
9. Reinstall the drain plug and new gasket. Tightening torque: 19.6-29.4 N.m
(14.4 - 21.6 ft-lb, 2.0 - 3.0 kgf-m)